- Slide callipers
- Measuring plates
- Gauge blocks
- Meters and measurements
- Thickness gauges
- Threaded plug gauges
- Threaded ring gauges
- Piston gauges
- Granite slabs
- Radwag and Mar-Mit
- Torque wrenches
- Torque screwdrivers
- Hardness testers
The quality of your product begins in our laboratory.
Measuring stations for length and angle calibration
The ABBE super micrometer is used for measuring lengths up to 700 mm, inner and outer ring diameters up to 250 mm, inner and outer thread parameters, clock sensors and diameters.
The quality of our calibration procedures and quality verification system is confirmed by the implemented ISO 17025 standard and PCA AP156 accreditation.
All measurements are conducted in accordance with METNAV procedures, recommendation of manufacturers, own procedures based on EURAMET recommendations, military procedures or procedures specified by the ordering party.
Measuring stations for Length and Angle calibration – Length measurements
We perform measurements of slide callipers and rigid gauges up to 5000 mm, micrometers and micrometer depth gauges, analog and digital clock sensors. Rolled tape measurements are conducted with the use of Polmiar length 5 meter standard instrument, calibration certificate issued by the (GUM) National Measurement Office
Measuring stations for Length and Angle calibration – Optical Comparator
Instrument to verify and measure standards for threads, arc and diameter standards, angle standards
Measuring station for torque wrenches
Measuring station for testing torque screwdrivers and torque wrenches up to 3000N. We do have Mountz S-100, Stahlwille Sensotork 7723-2, 10 – 400N and Stahlwille 7724-1, 300 – 3000N at our disposal.
The pneumatic wrench measuring station for impact wrenches up to 680 Nm are done by tester from Checkline-USA
Each calibration is completed by the generation of a certificate confirming the proper operation of the instrument. Our certificates and measurement results will guarantee you the documentation that will satisfy the requirements of ISO-9001 and other standards, at the same time certifying that the calibration procedure has been carried out correctly.
In addition, you can be sure that the instrument is operating with maximum tolerance and has been calibrated with the test instruments specified on the certificate and recommended by the manufacturer of your instrument.
We are the only authorized FLUKE Service Center in Poland.
Instruments calibrated by ANMAR receive a calibration certificate with the logo of the ANMAR and FLUKE company and the results of measurements, which proves the highest quality of services, model equipment (calibrators) and computer programs (MetCAL) at our disposal, used and recommended also by the manufacturer’s laboratories.
FLUKE calibrators of electrical parameters are available in our laboratory:
FLUKE 5700A, FLUKE 5520A/600 MHz, FLUKE 5520A/1100MHz/PQ, FLUKE 5320A/40, FLUKE 5080A, DATRON 4800/4900, DATRON 4950, FLUKE 8508A, WAVETEK 9100